Cedar Electronics

Please be sure to perform the following steps in the listed order. BEFORE YOU START Turn off all accessories on the vehicle (headlights, etc.).Look at ...

1. The JumPack might not be fully charged.  Press the button on the JumPack to test the battery condition.  All four LEDs should illuminate. 2. There might...

To maintain a full charge on your JumPack, it is recommended to charge it every few months. If you keep the JumPack in your home, leave the charger plugged...

TO CHECK THE STATUS OF THE INTERNAL BATTERY Press and release the button.  If the battery is fully charged then all four LEDs will illuminate. TO TURN ...

To turn on the light, press and hold the button on the JumPack. After a few seconds the light should illuminate. If the light does not turn on, then the bat...

WARNING:  When connecting and disconnecting the battery cables, always make sure that the jump starter is turned off (big yellow knob in the OFF position). ...

There are four basic possibilities why your car did not start: 1. The jump starter might not be fully charged. Press the battery test button on the jump st...

To maintain a full charge on your jump starter, it is recommended to charge it once per month. If you keep the jump starter in your home, leave the charger...

The cigarette socket in your car does not supply a properly regulated voltage suitable for charging your jump starter.  Only the AC charger should be used f...

The battery meter is a bar graph.  If the battery is low, then only 1 or 2 of the LEDs will light up. When the battery is full, all 4 LEDs will light up.  ...