Cedar Electronics

Please be sure the power cord is plugged into the USB port on the bracket, not directly on the camera. If you made changes in the menu, please restore it to...

Must stop recording mode first by tapping once on (Record/Select) button. Press Menu button once. Tap “Up” button twice to highlight “Restore Defaults”. The...

You must stop recording mode first by tapping (Rec/select) button at the TOP right of the unit. The word REC should disappear from the screen. Then: 1. Pres...

You must stop recording mode first by tapping the (Rec/select) button at the TOP right of the unit. The word REC should disappear from the screen. Then foll...

Stop recording mode by tapping on "Record/Select" button once. 1. Tap on "Mode Switches" a couple of times to access video files. 2. Use...

Please check the menu settings to make sure "video clip time" is set to 3, 5 or 10 minutes. If it has an "X" next to it, the camera reco...

If the video clip time is set to 3, 5 or 10 minutes, then change the "G-sensor" sensitivity to "low" to prevent it from locking so many ...

Please note, you may use a standard SD card. However, for best video quality, we recommend using Class 6 or Class 10 SD cards.

The video clip time is probably set to (X). In order for it to loop, it MUST be set to 3,5 or 10 minutes. Check video settings.

DOWNLOAD UPDATE  This Update Includes: G-Sensor Sensitivity Adjustment – In previous firmware versions the G-Sensor settings are too sensitive for many c...